Conducting A Videoconference Using The Dual Video Function; System Configuration Using 2 Cameras And 3 Monitors - Sony PCS-G50 System Integration Manual

1-7. Conducting a Videoconference Using the Dual Video Function

The dual video function allows the simultaneous sending and receiving of two images using two cameras.
n
PCS-G50/G50P can be used for only reception.

1-7-1. System Configuration Using 2 Cameras and 3 Monitors

This section describes how to configure a system using 2 cameras and 3 monitors.
m
. For connecting power cables and communication units/cables, refer to "1-3. System Connections".
. Be sure to turn off all the equipment before making any connections.
. Do not connect/disconnect the camera cable with the power on. Doing so may damage the camera unit
or communication terminal.
First monitor
Additional monitor A
(projector, etc.)
. To conduct a videoconference using the dual video function, the H.239 setting of the Communication
Setup menu of both local and remote terminals must be "On".
. Up to four monitors can be connected to the system. However, only three monitors, including the first
monitor, can be used at one time.
. The dual video function can only be used in a two-point videoconference.
n
PCS-DSB1 (not supplied) is also available for the data solution box.
PCS-G70/G70P/G50/G50P
First camera
PCSA-CG70/
CG70P Camera
unit (supplied)
Camera cable
(supplied)
to MAIN CAMERA
to RGB
to VIDEO OUT
OUT
MONITOR 2
to S-video input
S-video cable (not supplied)
Second camera
Camera cable (supplied)
to SUB CAMERA
PCS-PG70/PG70P
Communication terminal
to DSB
PCSA-DSB1S
Data solution box
(not supplied)
Additional monitor B
(projector, etc.)
Signal cable
(not supplied)
Additional monitor C
(projector, etc.)
Signal cable
(not supplied)
1-45