Sony PCS-G50 System Integration Manual page 35

(PCS-G50/G50P)
Menu Page Item 1
Audio Setup 2/2 Beep Sound
Sound Effect
Dial Tone
Ringer Tone
Video Setup 1/1 Video Input
Custom Input 1/1
Label
Monitor Out
General Setup 1/1 Device Setup 1/2
1/1 Clock Set
PCS-G70/G70P/G50/G50P
Page Item 2 Description
Select "On" to generate beep sound from pressing the
remote commander button. Select "Off" not to generate.
Select "On" to generate effect sound at system start up and
conference start/end. Select "Off" not to generate.
Select "On" to generate ring-back tone or busy tone during
dialing. Select "Off" not to generate.
Select "On" to generate ringer tone with an incoming call.
Select "Off" not to generate
1/1 VIDEO IN Select video picture of video input 1.
Main Camera Enter the name when "Main Camera" is selected on the
video input selection window.
IR1 Enter the name when "IR1" is selected on the video input
selection window.
AUX1 Enter the name when "AUX1" is selected on the video input
selection window.
1/1 Monitors Select the number of monitors connected to the
communication terminal.
Connection Select connectors connecting to the monitors. You can
select them up to the number specified in "Monitors".
Monitor Select "Main" or "Sub" for connected monitors to be used as.
Only one "Main" monitor can be selected. When 1 or 3
monitors are used, VIDEO1 is always "Main" monitor.
Terminal Name Enter terminal name to be notified to remote parties.
Standby Select "On" when using standby mode. Select "Off" when
Mode not using it.
Standby Set the time (1 to 99 minutes) required until the unit is put
Time into standby mode when standby mode is set to "On".
Last Number Select "On" when registering the remote user in Phone Book
Registration after a conference ends. Select "Off" when not registering it.
Control by Select "On" when receiving camera control command from
Far End the remote party. Select "Off" when not receiving it.
2/2 Language Select language of menu and message displayed on the
screen.
IR Repeater Select mode to put the monitor into standby state or to turn
Mode on power when a Sony's monitor is used. Usually, set to
"MODE 1".
T.120 PC Enter the IP address of computer used when data
Address conference conforming to T.120 is made using NetMeeting.
Digital Zoom Select "On" when using Digital Zoom. Select "Off" when
not using it.
1/1 SNTP Select "On" when obtaining clock information from the server
with SNTP. Select "Off" when not obtaining it.
Time Zone Select the country or region where you are using the
communication terminal.
Summer Select "On" during summer time. Select "Off" when not in
Time summer time.
SNTP Server Input the server address to obtain the clock infomation from.
Clock Set Enter the current data and time.
Default
On
On
On
On
CAMERA
Blank
Blank
Blank
1
VIDEO1
Main
PCS-G50
Off
Blank
On
On
English
MODE1
Blank
Off
Off
Blank
Off
Blank
Blank
(Continued)
1-31