Sony PCS-G50 System Integration Manual page 16

3. Set a monitor that outputs a signal.
n
No menus other than the selected monitor(s) will be
displayed.
Monitor Setup Wizard
Monitors 3
VIDEO1 VIDEO2 RGB OUT
Connection
Main Sub
Monitor
Previous Next
Monitors:
Select the number of monitors connected to the
system.
1: One monitor connected.
2: Two monitors connected.
3: Three monitors connected.
Connection:
Selects the output connector to which the device to be
used is connected.
VIDEO 1: Selects the device connected to
the VIDEO 1 connector.
VIDEO 2: Selects the device connected to
the VIDEO 2 connector.
RGB OUT: Selects the device connected to
the RGB OUT connector as the
main monitor.
RGB OUT (DSB): Selects the device connected to
the RGB OUT connector on the
data solution box.
Monitor:
Define the monitor connected to the corresponding
connector as the main monitor or the sub monitor.
Main: Defines the monitor as the main monitor.
Sub: Defines the monitor as the sub monitor.
4. Select "Next" using the , , , or
remote commander, then press the PUSH ENTER
button.
The ISDN Setup Wizard is displayed when the ISDN
unit is connected.
When the ISDN unit is not connected, the LAN setting
wizard is displayed. Proceed to step 11.
1-12
RGB OUT(DSB)
Sub
Cancel
button on the
5. Set the country/region and protocol in which an ISDN
line is used.
ISDN Setup Wizard
Country/Region
Protocol National ISDN
Previous Next
Country/Region:
Select the country or region in which this system is
used.
Protocol:
Select the protocol of the ISDN line used.
6. Select "Next" using the , , , or
remote commander, then press the PUSH ENTER
button.
Cancel
button on the
PCS-G70/G70P/G50/G50P