Sony PCS-G50 System Integration Manual page 61

Operating with Administrator Authority in PCS
Integration
When you connect using the administrator authority, you
can change the settings of a network camera from the PCS-
G50/G70. You can change the settings through the Net-
work Camera page in the PCS's General Setup menu. (For
details, see section 1-11-5.) If "Auto" is selected for "Bit
Rate," "Frame Rate," "Mode" and "Image Size," the
connection is made using the settings of the connecting
network camera.
If the connection is made using the administrator authority
with the setting items set to "Auto," the connection can be
made by properly changing the network camera settings
even if a preconfigured item in the network camera setup is
not supported by the PCS-G50/G70.
In addition, the far end camera control and preset functions
can be used under the administrator authority.
When the network camera settings are changed via the
PCS-G50/G70, the previously set network camera settings
are automatically restored after communication has ended.
m
. Connections made using the administrator authority
automatically change the network camera settings and
may affect a monitoring system using the network
camera, so you must consult with your system adminis-
trator beforehand.
. If a connection shuts down due to a failure such as a
blackout, the settings cannot be restored. It is therefore
recommended to save the camera's setting data in a file
prior to connection. For details on how to save/restore
the setting data, see the User's Guide that came with the
network camera.
When a connection to a network camera is made using the
administrator authority, the modes described below will
automatically be changed.
. Audio Codec
If the audio codec setting (used to send audio) of the
network camera is G.726, it will automatically be
changed to G.711.
. Audio (Bidirectional)
If the audio upload setting of the network camera is
disabled, it will automatically be enabled to perform
voice communication from the video communication
terminal to the network camera. If the microphone
setting of the network camera is OFF, it will automati-
cally be turned ON to perform voice communication
from the network camera to the video communication
terminal as well.
PCS-G70/G70P/G50/G50P
. Multicast Streaming
If the multicast streaming setting of the network camera
is OFF and the connection is made through UDP (Multi-
cast), multicasting will automatically be turned ON for
the connection using UDP (Multicast).
. Unicast Streaming
If the network camera's unicast streaming setting (video
or audio port number) overlaps with the port number
used by the PCS-G50/G70, it will automatically be
changed to another number for connection.
Operating with User Authority in PCS Integration
You cannot change the network camera setting items
through the PCS-G50/G70. You must use the network
camera to configure settings related to the connection with
the PCS-G50/G70. (Settings configured through the
Network Camera page in the PCS's General Setup menu
will be disabled.)
To use the camera control and preset functions via the
PCS-G50/G70, you must properly configure the network
camera's User menu.
For details, see Table 1 mentioned above and section 1-11-
8.
1-57