Configuring Video Surveillance On The Cisco Spa 525G - Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual

Customizing Cisco SPA and Wireless IP Phones

Configuring Video Surveillance on the Cisco SPA 525G

STEP 6
Configuring Video Surveillance on the Cisco SPA 525G
NOTE
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Click Submit All Changes. The phone reboots.
You must also configure the Extension Mobility parameters in the profile rule field
in the Provisioning tab. See the
Cisco SPA500 Series IP Phones
https://www.myciscocommunity.com/docs/DOC-11277
For more information on extension mobility and BroadSoft, see
http://www.broadsoft.com.
The Cisco SPA 525G provides a simple video surveillance solution for a small
business office. The Cisco SPA 525G works with the Cisco WVC2300 Wireless-G
Business Internet Video Camera and the Cisco PVC2300 Business Internet Video
Camera to provide simple video monitoring from your IP phone of a location such
as a lobby entrance or doorway. Up to four cameras can be monitored from one IP
phone.
Camera audio is not supported.
The Cisco SPA 525G connects to the videocamera and provides a real-time video
stream display from the camera. Storage and manipulation of video and physical
camera control are not available from the IP phone.
The IP phone supports the camera display at a rate of two to three frames per
second with good video quality. However, video quality can degrade if the camera
is processing multiple streaming sessions, there is heavy Wi-Fi network traffic, or
the IP phone is performing other processing. To avoid degrading voice audio
quality on a call, the frame rate decreases to one frame per second if a codec
other than G.711 is used for a call or when the user accesses the video monitoring
page during a call.
To configure the video surveillance feature, perform the steps outlined in the
following sections.
Provisioning Parameters for Extension Mobility on
application note at:
3
77