Localizing Your Ip Phone - Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual

Configuring Regional Parameters and Supplementary Services

Localizing Your IP Phone

Localizing Your IP Phone
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
To get better detection by the IVR, avoid inband and use OOB. This way, the DTMF
tone is reconstructed by the PSTN gateway or the remote endpoint, and the
quality is not subject to distortion from the audio codec. If you use OOB, use a
slightly longer DTMF Playback Length.
If you use inband, use a higher Inband DTMF boost.
The following table describes the localization parameters in the
section.
Field
Set Local Date
(mm/dd)
Set Local Time
(HH/mm)
Time Zone
Time Offset (HH/
mm)
Daylight Saving
Time Rule
Daylight Saving
Enable
Dictionary Server
Script
Description
mm
Enter the local date (
the day). The year is optional and uses two or four digits. For
example,
May 1, 2008, can be entered as:
05/01 or 05/01/08 or 05/01/2008
hh
Enter the local time (
minutes). Seconds are optional.
Selects the number of hours to add to GMT to generate the local
time for caller ID generation. Choices are GMT-12:00, GMT-
11:00,..., GMT, GMT+01:00, GMT+02:00, ..., GMT+13:00.
Defaults to GMT-08:00.
This specifies the offset from GMT to use for the local system
time.
Enter the rule for calculating daylight saving time. See the
"Configuring Daylight Savings Time" section on page
Select yes to enable or no to disable DST on the phone. This
setting affects all lines (extensions) on the phone.
Defines the location of the dictionary server, the languages
available and the associated dictionary. See the
Dictionary Server Script" section on page
represents the month and
mm
represents hours and
167.
7
Miscellaneous
dd
represents
represents
164.
"Creating a
162