Download Print this page
Cisco 8961 Setup Manual
Cisco 8961 Setup Manual

Cisco 8961 Setup Manual

Setting up the cisco unified video camera
Hide thumbs Also See for 8961:

Advertisement

Setting Up the Cisco Unified Video Camera
The Cisco Unified IP Phone 9951 and 9971 supports the add-on accessory Cisco Unified Video Camera.
The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make a
point-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera
attached. If a phone does not have a Cisco Unified Video Camera attached, it can only receive one-way
video.
This chapter contains the following information:

Configuring the Cisco Unified Video Camera

To configure the Cisco Unified Video Camera, you must perform the following configuration steps in
Cisco Unified Communications Manager administration:
Note
The parameters described in the following procedure can be enabled on either the Phone Configuration
window (Device > Phone), the Enterprise Phone Configuration window (System > Enterprise Phone
Configuration), or the Common Phone Profile window (Device > Device Settings > Common Phone
Profile). Be sure to also check the corresponding Override Common Settings parameter in the
configuration window. The Phone Configuration window is referenced below for purposes of the
procedure description.
For more information about parameters that can be configured in any of these three configuration
windows, see the
Procedure
In the phone configuration window (Device > Phone) of the phone to which you are adding the Cisco
Step 1
Unified Video Camera, enable the Cisco Camera parameter. This field is located in the Product Specific
Configuration layout portion of the window.
Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP)
OL-20862-01
Configuring the Cisco Unified Video Camera, page 5-1
Attaching the Cisco Unified Video Camera, page 5-2
Adjusting the Camera Settings, page 5-2
Post-Installation Steps, page 5-4
Using the Cisco Unified Video Camera, page 5-4
"Configuring Product Specific Configuration Parameters" section on page
5
C H A P T E R
8-20.
5-1

Advertisement

loading

Summary of Contents for Cisco 8961

  • Page 1: Configuring The Cisco Unified Video Camera

    The Cisco Unified IP Phone 9951 and 9971 supports the add-on accessory Cisco Unified Video Camera. The Cisco Unified Video Camera connects to your Cisco Unified IP Phone and allows you to make a point-to-point video call with another Cisco Unified IP Phone with a Cisco Unified Video Camera attached.
  • Page 2: Attaching The Cisco Unified Video Camera

    The USB port connector on the bottom of the Cisco Unified Video Camera attaches to the back port (not the side port) on the Cisco Unified IP Phone 9951 or 9971. As you attach the USB connector to the back port on the phone, the camera should slide easily into the camera pin holes on the phone.
  • Page 3: Adjusting The Brightness Setting

    To turn the Auto Transmit setting on or off, follow these steps: Procedure On the Cisco Unified IP Phone, press the Applications button Step 1 Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP) OL-20862-01...
  • Page 4: Using The Cisco Unified Video Camera

    For information about placing and receiving video calls, setting up video conferences, and adjusting camera settings on the phone, see the Cisco Unified Video Camera Quick Start Guide at this location: http://www.cisco.com/en/US/docs/voice_ip_comm/cuipph/9971_9951_8961/8_0/english/user/qsg/qs99 camen80.pdf Cisco Unified IP Phone 8961, 9951, and 9971 Administration Guide for Cisco Unified Communications Manager 8.0 (SIP) OL-20862-01...

This manual is also suitable for:

99519971