Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual page 139

Configuring Security, Quality, and Network Features
Configuring VLAN Settings
STEP 1
STEP 2
STEP 3
STEP 4
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
• Obtains the protocol addresses of neighboring devices and also discovers
the platform of those devices.
• Shows information about the interfaces your router uses.
• Is media and protocol-independent.
If you are using a VLAN without CDP, you must enter a VLAN ID for the IP phone.
Log in to the web administration interface.
Click Admin Login and advanced.
Click the System tab.
Enter the following parameters:
Parameter
Enable VLAN
Enable CDP
VLAN ID
Enable PC Port VLAN Tagging
PC Port VLAN Highest Priority
Description
Choose Yes to enable VLAN. Choose no to
disable.
Enable CDP
only if you are using a switch that
has Cisco Discovery Protocol. CDP is
negotiation based and determines which VLAN
the IP phone resides in.
If you use a VLAN without CDP (VLAN enabled
and CDP disabled), enter a
phone. Note that only voice packets are tagged
with the VLAN ID.
Enables VLAN and priority tagging on the phone
data port (802. 1 p/q). This feature facilities
tagging of the VLAN ID (802. 1 Q) and priority bits
(802. 1 p) of the traffic coming from the PC port of
the IP phone.
Defaults to No. Choose Yes to enable the
tagging algorithm.
Choose No Limit, or 0-7 (default 0). The highest
priority is 7. The priority applied to all frames,
tagged and untagged. The phone modifies the
frame priority only if the incoming frame priority
is higher than this value.
5
VLAN ID
for the IP
128