Configuring Daylight Savings Time - Cisco WIP310 - iPhone Wireless VoIP Phone Administration Manual

Configuring Regional Parameters and Supplementary Services
Localizing Your IP Phone
NOTE
Cisco SPA 500 Series and WIP310 IP Phone Administration Guide
Time Zone Time Offset (HH/mm)
The and
time and date setup.

Configuring Daylight Savings Time

The phone supports auto adjustment for daylight saving time. You must set
Daylight Savings Time Enable
CallerID
time stamp on
To enter the rule for calculating DST, include the start, end, and save values
separated by semi-colons (;) as follows:
Start = start-time; end=end-time; save = save-time
For example, the default DST rule is
start=4/1/7;end=10/-1/7;save=1.
start-time end-time
The and
daylight saving time. Each value is in this format:
month
The value equals any value in the range 1-12 (January-December).
day
The value equals any + or - value in the range 1-31. If day is 1, it means the
weekday on or before the end of the month (in other words the last occurrence of
weekday in that month).
weekday
The value equals any value in the range 1-7 (Monday-Sunday). It can also
equal 0. If the weekday value is 0, this means that the date to start or end daylight
saving is exactly the date given. In that case, the day value must not be negative. If
the weekday value is not 0 and the day value is positive, then daylight saving starts
or ends on the weekday value on or after the date given. If the weekday value is
not 0 and the day value is negative, then daylight saving starts or ends on the
weekday value on or before the date given.
Optional time values:
ss
and represents seconds (0-59). Optional values inside brackets [ ] are assumed
to be 0 if not specified. Midnight is represented by 0:0:0 of the given date.
save-time
The value is the number of hours, minutes, and/or seconds to add to the
current time during DST. The
minus (-) sign to indicate addition or subtraction.
offset values are
to yes and enter the DST rule. This option affects the
.
values specify the start and end dates and times of
HH
represents hours (0-23),
save-time
value can be preceded by a plus (+) or
not
applied to manual
month/day/ weekday[/HH:mm:ss]
mm
represents minutes (0-59).
7
164