Intellijel Metropolix Manual page 92

In Use:
1. Press either the TRK 1 or TRK 2 button, depending on which track's per-stage gates you wish
to edit.
2. Press the EDIT button, followed by the GATE button.
The screen displays an overview of every stage's gate length overrides, and the eight stage
buttons are used to select which stage you wish to edit.
3. Press the button corresponding to the stage you want to edit.
That stage's button will flash
screen, the downward pointing arrow indicates the edited stage, and the Action Display at the
bottom also indicates the Track:Stage currently being edited.
4. Turn the encoder to set a gate length override for that stage.
This setting always overrides the track's GATE length setting.
5. Repeat Steps 3-4 for any other stages to which you wish to assign pitch or gate values.
As long as you remain on the GATE edit screen, any of the eight stage buttons to which you've
assigned a GATE override will light green.
Various shortcuts are also available:
● Long-press the encoder to remove the gate length override from the current stage.
● Hold the ALT button while turning the encoder to change the gate length override across all
stages simultaneously. Alternatively, you can press the ALT button to enter ALT mode, then turn
the encoder, and then press the ALT button again to exit ALT mode.
● Hold the ALT button and long-press the encoder to remove the gate length overrides from all
stages.
green to indicate which stage number is being edited. On the
Metropolix Manual 91