Intellijel Metropolix Manual page 90

In Use:
1. Press either the TRK 1 or TRK 2 button, depending on which track's per-stage pitches you wish
to edit.
2. Press the EDIT button, followed by the PITCH button.
The screen displays an overview of every stage's Pitch Override, and the eight stage buttons
are used to select which stage you wish to edit.
3. Press the button corresponding to the stage you want to edit.
That stage's button will flash
screen, the downward pointing arrow indicates the edited stage, and the Action Display at the
bottom also indicates the Track:Stage currently being edited.
4. Turn the encoder to assign a pitch override (note value) to the current stage.
If you turn the encoder fully counterclockwise (value is '--'), then no pitch override is applied to
the stage.
5. Alternatively, you can push the encoder to synchronize (set) the current stage's
PITCH OVERRIDE to the PITCH SLIDER'S position at that stage.
SHORTCUT: You can match all 8 stage's PITCH OVERRIDE values to the current PITCH
SLIDER positions by holding ALT while pushing the encoder.
6. Repeat Steps 3-5 for any other stages to which you wish to assign pitch overrides.
As long as you remain on the PITCH edit screen, any of the eight stage buttons to which you've
assigned a pitch override will light yellow.
Various shortcuts are also available:
● Long-press the encoder to remove the pitch override from the current stage.
● Hold the ALT button while turning the encoder to change the pitch override across all stages
simultaneously. Alternatively, you can press the ALT button to enter ALT mode, then turn the
encoder, and then press the ALT button again to exit ALT mode.
● Hold the ALT button and long-press the encoder to remove pitch overrides from every stage.
yellow to indicate which stage number is being edited. On the
Metropolix Manual 89