Intellijel Metropolix Manual page 174

Creating a Preset Chain
If you have never created a chain (or one is not currently loaded into flash memory), you'll see a
blank PRESET CHAIN screen when you first access it. If the screen shows an existing Preset
Chain, you can clear it.
To clear a Preset Chain from flash memory:
Turn the encoder to the end of the chain list, and highlight the Clear Chain item.
1.
2. Press the encoder.
The Preset Chain that was loaded into memory is cleared, and a fresh new chain can be
programmed.
Once you have an empty Preset Chain, you can create a new one.
To create a new Preset Chain:
1. Turn the encoder to highlight the "New Chain" option at the top of the PRESET CHAIN screen.
2. Press the encoder to begin editing the first link in the Preset Chain.
The Preset parameter highlights, indicating this is what you'll first be editing.
3. Turn the encoder to select a different Preset Bank colour, then press one of the eight stage
buttons to select which preset number to assign to the link.
Press the encoder again, highlight just the Repeat parameter for editing.
4.
5. Turn the encoder to select the number of times to repeat playback of the Preset's sequence.
6. You can also set the Track and MOD Lane mute states (indicated by the flashing Mute state
indicators). To do so, simply press the TRK 1, TRK 2, or MOD buttons to mute/unmute the
corresponding Track.
buttons (and solid circles in the Mute column) indicate unmuted tracks. Flashing
Yellow
buttons (and hollow circles in the Mute column) indicate muted tracks.
When you're done defining a link's Preset, Repeat and Mute parameters, press the encoder
7.
again to move to the next link, and repeat steps 3-7 for each link you create.
8. When finished, press the EXIT button to exit out of the chain creation UI.
Metropolix Manual
red
173