Intellijel Metropolix Manual page 100

ACCUM
Press EDIT + ACCUM to access the per-stage ACCUMULATOR feature. This lets you diatonically
and cumulatively increase or decrease a stage's pitch as the sequence continues to cycle. You can
define when each transposition occurs (either on each STAGE; each PULSE; or each RATCHET),
and you can also define the amount of transposition to apply with each accumulation, and the range
over which those transpositions occur. Using the Mode option on the
whether the accumulator applies only to the current stage, or to the entire track.
To edit a Stage's accumulator value, press the Stage button corresponding to the Stage you wish to
edit.
There are two main parameters accessible by the button:
● TRANSPOSE AMOUNT : Turning the encoder sets the amount of transposition that occurs on
each pass. Transpose values relate to the current SCALE, and are expressed as a number of
scale degrees (°), with ±7 being the default.
● TRANSPOSE TRIGGER : Pressing the encoder cycles through the three choices for what triggers
each transposition (i.e. when the accumulation occurs). The choices are:
'Stage' : Applies the transposition amount each time the stage is played. This is the default
selection.
'Pulse' : Applies the transposition amount each time a pulse is played.
'Ratch' : Applies the transposition amount each time a ratchet event is played.
Metropolix Manual
LIM screen, you can also set
99