Intellijel Metropolix Manual page 119

OUT Assignments In Use:
1. Press the ALT button followed by the
the OUT A (or OUT B) Assignment Screen.
2. Press the encoder to toggle between editing the OUTPUT <n> and OUTPUT ASSIGN
parameters.
3. With the OUTPUT <n> parameter active (and the
select which signal type you wish to send to the output.
A question mark (?) follows the name of each option, indicating you must press the encoder to
confirm it. A (?) does not appear next to the name of the currently applied option.
4. Press the encoder to confirm your choice.
5. With the OUTPUT ASSIGN parameter active (and the
select which Track (or MOD Lane) is the source of the OUTPUT <n> signal.
Specifically, if you selected any OUTPUT <n> parameter other than 'Mod', 'Run' or a CTRL <n>
knob, turning the encoder selects the source track. If OUTPUT <n> = Mod, turning the encoder
selects one of eight MOD Lanes as the source. If OUTPUT <n> = Run (or CTRL <n>), the source
is global and the output assignment can not be edited.
A question mark (?) follows the assignment option, indicating you must press the encoder to
confirm it. A (?) does not appear next to the name of the currently applied option.
6. Press the encoder to confirm your choice.
7. To reset all Output Assignment parameters back to their default values, long-press the encoder.
A (Stage 3) button (or the
indicator beside it), turn the encoder to
indicator beside it), turn the encoder to
Metropolix Manual
B (Stage 4) button) to open
118