Intellijel Metropolix Manual page 143

Turning an encoder edits the active (enclosed) parameter. Pressing the encoder toggles
activation to the other parameter for editing.
NOTE: If a MOD Lane is routed to one of Metropolix' two OUT jacks (as described in
a MOD Lane to an OUT
MOD PARAM : With the MOD PARAM field active, turn the encoder to select which
internal parameter you wish to modulate with the currently selected
MOD Lane. Choices are:
None
Accumulate (⎍)
Accum Reverse (⎍)
Accum Invert (⎍)
Accum Mode (⎍)
Accum Polar (⎍)
Accum Reset (⎍)
BPM (INT)
Clock In Div
Direction (⎍)
Gate Length
Gate Scale
Loopy (⎍)
The list above indicates Gate and Trigger signals with a gate symbol (⎍),
meaning the indicated function will occur when the gate is high (or the
leading edge of the trigger signal is detected). Gate or trigger signals
must be at least 1.5V to turn on.
See
option.
MOD ASSIGN :
This parameter displays which Track(s) you wish to modulate. To set it:
Jack), then a small indicator appears, as shown above.
AUX & MOD DESTINATIONS
a) Press the encoder to activate editing of the MOD ASSIGN field.
b) Rotate the encoder to set the indicated MOD Lane's destination to
either TRK 1, TRK 2, or TRK 1+2.
c) Press the encoder to apply your selection.
Metropolix Manual
Loopy Pulses Reset (⎍)
Loopy Offset Root
Mute (⎍) Scale (User)
Octave Skip Invert (⎍)
Pitch Offset Slide (⎍)
Pitch Post Slide Amount
Pitch Pre Slider Invert (⎍)
Play Order Slider Range
Probability Stages Len
Pulse Count Stage Offset
Pulse Div Swing
Pulses Len Trk Out Swap (⎍)
Ratchet Velocity
for a detailed description of each
Assigning
142