Network Settings - Spectra Logic T-Series Spectra T950 User Manual

Network Settings

Note: The LC automatically reboots when you save network settings.
By default, the library is configured to use Dynamic Host Configuration Protocol
(DHCP). Follow these steps to change or edit the network protocol.
1. From the System Setup screen (Figure 7-3 on page 84), select Edit next to
Network Settings.
This brings up the Network Settings screen (Figure 7-4).
Figure 7-4 The Network Settings screen.
2. Determine which type of addressing the library network uses, then either:
• Select DHCP
or
• Select Static (highly recommended):
• Enter the static address in the Address field.
• Enter the subnet mask in the Subnet field.
• Enter the network gateway in the Gateway field.
• Select Save to finish.
3. Select Save to finish.
The library is now configured to use the new settings.
Chapter 7. Configuring the Library
85