Network Settings - Spectra Logic T-Series Spectra T50 User Manual

Network Settings

Static IP Addressing
The library uses Dynamic Host Configuration Protocol (DHCP) by default.
Follow these steps only to change or edit the network protocol.
Note: If you plan to use RLC, Spectra Logic recommends setting a static
IP address for the library.
Before Setting the Static IP Address
Make sure of the following:
• The library has a network connection with an active link.
• The IP address is unique and is not in use by another device.
Note that if you configure an address that has already been assigned to another
device, you must zone your switch so that the port connected to the library does
not reach the device with the same IP address.
Setting the Static IP Address
To set a static IP address:
1. Log in as a user in either the superuser or administrator group.
2. Select Configuration > Network. The Network screen appears (Figure 5-3).
Chapter 5. Configuring Library Settings
Figure 5-3 The Network screen.
29