Spectra Logic T-Series Spectra T950 User Manual page 77

4. Select Import Storage TeraPacks.
Note: Import for Storage is used for initial library load; after this, you
should typically use Import for Entry/Exit, and then move media
into the storage pool through the backup software. Alternately, if
your backup software needs to control all initial media imports,
select Import for Entry/Exit here.
After making your selection, the TAP opens and a Feedback Required screen
appears.
5. Insert a loaded TeraPack container or a RXT media pack into the open TAP,
making sure that the TeraPack container or RXT media pack is facing the correct
direction (Figure 6-3).
• The TeraPack container or RXT media pack slips easily onto the tabs on the
front of the lowered TAP door.
• The arrows on the sides of a
TeraPack container point inward,
toward the library.
Arrows
Figure 6-3 Correct insertion of a TeraPack container (left) and RXT media pack (right).
6. Select Continue in the Feedback Required screen.
The bulk loading process continues automatically as long as there are empty
chambers to fill; simply continue to load the TAPs and select Continue each time.
If all chambers become full, the process stops automatically and the LC displays
the Import/Export TeraPacks screen.
If you finish importing before all chambers are full, select Stop Importing.
Typically, you'll load all storage chambers, so that the partition's storage pool is
full. If any chambers are empty, they are tagged as inaccessible; without a
TeraPack container, the library has no slots to access.
Chapter 6. Loading Media for the First Time
Tabs
77
• The handle on the front of the RXT
media pack faces outward, towards
you.
Handle
Tabs