Removing The Computer Cover - Compaq 159715-002 - Deskpro EN - DT 6650 Model 10000 Configuration Manual

Removing the
Computer Cover
3-4 Upgrading the Compaq Deskpro EN Series, Small Form Factor
If vent holes are located in the bottom of the mounting
drawer, allow at least 1 inch (2.54 cm) of clear space below
the drawer to ensure proper air flow.
At least 1 inch (2.54 cm) of clear space above the top of the
chassis.
To install optional equipment, you must remove the computer
cover to gain access to internal components. The quick release
cover latches located on the sides of the computer allow easy
removal of the computer cover without the use of tools. To
remove the cover, follow these steps:
1. If you have locked the Smart Cover Lock, use Computer
Setup to unlock it.
2. Turn off the computer and any external devices.
3. Disconnect the power cord from the power outlet, and
disconnect any external devices.
WARNING:
Before removing the computer cover, ensure that the
!
computer is turned off and that the power cord is disconnected
from the electrical outlet.