Removing A Drive From The Drive Cage - Compaq 159715-002 - Deskpro EN - DT 6650 Model 10000 Configuration Manual

Removing a Drive
from the Drive Cage
10. Reconfigure the computer, if necessary. Refer to Appendix
B, "Computer Setup Utilities," for more information.
If you have installed a second diskette drive (B), you will
need to reconfigure the computer, using Computer Setup,
to recognize the B drive. Choose the Storage/Diskette
Drives option, to enable the drive and select the drive size.
11. If you normally lock the Smart Cover Lock, use Computer
Setup to relock the lock and enable the Smart Cover
Sensor.
1. If you have locked the Smart Cover Lock, use Computer
Setup to unlock the lock and disable the Smart Cover
Sensor.
2. Shut down the operating system properly, turn off the
computer, disconnect the power cord from the electrical
outlet, and remove the computer cover.
3. Grasp the top of the tilt drive cage and rotate it to its
upright position.
4. Disconnect the drive power and signal cables and, if it is
a CD-ROM drive, disconnect the audio connector.
CAUTION:
Before completing the following step, note that the
drive slides easily out of the drive cage. Do not allow the drive to
strike a hard surface as it exits the drive cage. Excessive shock can
damage the drive.
Making Hardware Changes 4-29