When installing a SCSI device, be sure to route the SCSI cable
over the expansion board cage, between the raised areas.
For additional information about installing optional SCSI
devices, refer to the documentation that comes with the device
or contact your Compaq authorized dealer, reseller, or service
provider.
Using SCSI Select with SCSI Devices
The Wide Ultra2 SCSI host adapter includes the SCSISelect
utility to configure the host adapter and to run SCSI disk
utilities. To run the SCSISelect utility:
A menu appears with the following options:
In Post Messages Enabled mode: Press Ctrl+A when the
Press <Ctrl><A> for SCSISelect Utility message appears
during POST.
In Post Messages Disabled mode: When the Compaq logo
screen appears, press any key to exit the logo screen.
Immediately after exiting the logo screen, press Ctrl+A to
access the SCSISelect utility.
Configure/View Host Adapter Settings
SCSI Bus Interface Definitions
Host Adapter SCSI ID
–
SCSI Parity Checking
–
Host Adapter SCSI Termination
–
Additional Options
Boot Device Options
–
SCSI Device Configuration
–
Advanced Configuration Options
–
SCSI Disk Utilities
Lists all SCSI devices and SCSI ID numbers
For information about configuring POST message display
status, refer to Appendix B, "Computer Setup Utilities."
Making Hardware Changes
C-5