Perform The Initial Cas Configuration; Configuration Utility Script - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Installing the Clean Access Server
Only one CD is used for installation of the Clean Access Manager or Clean Access Server software. You
Caution
must select the appropriate type, either CAM or CAS, for the target machine on which you are
performing installation.
The Clean Access Server Package Installation then executes. The installation takes several minutes.
Step 9
When finished, the installation script presents the following message, prompting you to press Enter to
reboot the CAS and launch the Clean Access Server quick configuration utility.
Installation complete. Press <ENTER> to continue
When finished, the welcome screen for the Clean Access Server quick configuration utility appears, and
a series of questions prompt you for the initial CAS configuration, as described in
Script, page

Perform the Initial CAS Configuration

When installing the Clean Access Server from CD-ROM, the
appears after software package installation to prompt you for the initial CAS configuration.
Note If necessary, you can always manually start the
1.
2.
You can run the
be reached through the web admin console. For further details on CLI commands, see
Commands, page

Configuration Utility Script

The configuration utility script suggests default values for particular parameters. To configure the
Step 1
installation, either accept the default value or provide a new one, as described below.
After the software is installed from the CD and package installation is complete, the welcome script for
Step 2
the configuration utility appears:
Welcome to the Cisco Clean Access Server quick configuration utility.
Note that you need to be root to execute this utility.
The utility will now ask you a series of configuration questions.
Please answer them carefully.
Cisco Clean Access Server, (C) 2012 Cisco Systems, Inc.
Cisco NAC Appliance Hardware Installation Guide
3-24
3-6.
Over a serial connection or working directly on the CAS, log onto the CAS as user
root user password.
Run the initial configuration script by entering the following command:
service perfigo config
service perfigo config
3-43.
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Configuration Utility Script
Configuration Utility Script
command to modify the configuration of the CAS if it cannot
Configuration Utility
automatically
as follows:
with the
root
CAS CLI
OL-20326-01