Perform The Initial Cam Configuration; Configuration Utility Script - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Installing the Clean Access Manager
Next, the Cisco NAC Appliance software installer asks you to specify whether you are installing a Clean
Step 8
Access Manager or Clean Access Server. At the following prompt, enter
a Clean Access Manager.
Please choose one of the following configurations:
1) CCA Manager.
2) CCA Server.
3) Exit.
Only one CD is used for installation of the Clean Access Manager or Clean Access Server software. You
Caution
must select the appropriate type, either CAM or CAS, for the target machine on which you are
performing installation.
The Clean Access Manager Package Installation then executes. The installation takes several minutes.
Step 9
When finished, the installation script presents the following message, prompting you to press Enter to
reboot the CAM and launch the Clean Access Manager quick configuration utility.
Installation complete. Press <ENTER> to continue
After you press Enter, the welcome screen for the Clean Access Manager quick configuration utility
appears, and a series of questions prompt you for the initial configuration, as described in
Initial CAM

Perform the Initial CAM Configuration

When installing the Clean Access Manager from CD-ROM, the
automatically appears after the software packages install to prompt you for the initial configuration.
If necessary, you can always manually start the
Note
1.
2.
You can run the
be reached through the web admin console. For further details on CLI commands, see
Commands, page

Configuration Utility Script

The configuration utility script suggests default values for particular parameters. To configure the
installation, either accept the default value or provide a new one, as described below.
After the software is installed from the CD and package installation is complete, the welcome script for
Step 1
the configuration utility appears:
Welcome to the Cisco Clean Access Manager quick configuration utility.
Cisco NAC Appliance Hardware Installation Guide
3-6
Configuration, next.
Over a serial connection or working directly on the CAM, log onto the CAM as user
correct password.
Run the initial configuration script by entering the following command:
service perfigo config
service perfigo config
3-42.
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Configuration Utility Script
Configuration Utility Script
command to modify the configuration of the CAM if it cannot
to perform the installation for
1
Perform the
as follows:
with
root
CAM CLI
OL-20326-01