Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual page 78

Installing the Clean Access Manager
You entered 10.201.240.11 Is this correct? (y/n)? [y]
At the prompt, enter
the address you want to use for the trusted network interface in dotted-decimal format. Confirm the value
when prompted.
Step 7 Type the subnet mask for the interface address at the prompt or press enter for the default. Confirm the
value when prompted.
Please enter the netmask for the interface eth0 []: 255.255.255.0
You entered 255.255.255.0, is this correct? (y/n)? [y]
Specify and confirm the address of the default gateway for the Clean Access Manager. This is typically
Step 8
the IP address of the router between the Clean Access Manager subnet and the Clean Access Server
subnet.
Please enter the IP address for the default gateway []: 10.201.240.1
You entered 10.201.240.1. Is this correct? (y/n)? [y]
Provide a host name for the Clean Access Manager. The host name will be matched with the interface
Step 9
address in your DNS server, enabling it to be used to access the Clean Access Manager admin console
from a browser. The default host name is
Please enter the hostname [nacmanager]: cam3355
You entered cam3355 Is this correct? (y/n)? [y]
Specify the IP address of the Domain Name System (DNS) server in your environment:
Step 10
Please enter the IP addresses for the name servers: []: 63.93.96.94
You entered 63.93.96.94 Is this correct? (y/n)? [y]
The Clean Access Managers and Clean Access Servers use a local master secret password to encrypt and
Step 11
protect important data, like other system passwords. Cisco recommends keeping very accurate records
of assigned master secret passwords to ensure that you are able to restore database snapshots on the
CAM when you need them and are able to fail over to the HA peer CAM/CAS in HA deployments. (You
cannot upload a CAM database snapshot that was created when the system was configured with a
different master secret password, and HA-Secondary CAMs/CASs are not able to assume the "active"
role following a failover event when the master secret passwords are different.) Type and confirm the
master secret at the prompts.
The master secret is used to encrypt sensitive data.
Remember to configure all HA pairs with the same secret.
Please enter the master secret:
Please confirm the master secret:
Caution If your master secret is lost or becomes corrupted, use the procedure in
Secret, page
Specify the time zone in which the Clean Access Manager is located as follows:
Step 12
The timezone is currently not set on this system.
Please identify a location so that time zone rules can be set correctly.
Please select a continent or ocean.
a. Choose your region from the continents and oceans list. Type the number next to your location on
the list, such as
format, such as
The next list that appears shows the countries for the region you chose. Choose your country from
b.
the country list, such as
Cisco NAC Appliance Hardware Installation Guide
3-8
to accept the default address, or
y
3-48.
for the Americas, and press Enter. Type
2
.
GST-10
for the United States, and press Enter.
47
Chapter 3 Installing the Clean Access Manager and Clean Access Server
to specify another IP address. In this case, type
n
.
nacmanager
to enter the time zone in Posix TZ
11
Recover From Corrupted Master
OL-20326-01