Chapter 2
Preparing for Installation
Figure 2-10
Upper U
(For 2 U
system)
Lower U
Use a screwdriver to install the cage nuts or clip nuts on the inside of the mounting rail, as required for
Step 4
your particular rack, into the selected holes (see
Figure 2-11
Step 5
Use the tab on the rear of the slide rails to align the rear of the slide rail to the rear of the four-post rack.
Step 6
Select the best range among Posts A, B, C, and D to fit into the slots. Adjust the length of the slide rails
by moving around the depth adjustment screws and nuts (see
Step 7
Once you have the combination and fit you want for your NAC-3355/3395, reinstall and tighten the
screws and nuts for both slide rails.
OL-20326-01
Position Cage Nuts or Clip Nuts
Front
Optional screw
to secure system
into the rack
Clip or
cage nuts
Install Cage Nuts or Clip Nuts
Front
Front
Rear
Cage
Clip
nuts
nuts
Rack-Mounting Your Cisco NAC Appliance CAM/CAS
Rear
Figure
2-11).
Rear
Figure
Cisco NAC Appliance Hardware Installation Guide
2-12).
2-23