Configuring Boot Settings On The Cisco Nac Appliance Cam/Cas - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Serial Connection to the CAM and CAS
Configure the Port Settings as follows:
Step 6
•
•
•
•
•
Go to File > Properties to open the Properties dialog for the session and change the Emulation setting
Step 7
to
VT100
You should now be able to access the command interface for the CAM or CAS. You can now:
Step 8
•
•
•
•
Note If you already performed the initial installation, but need to modify the original settings, you can log in
as user

Configuring Boot Settings on the Cisco NAC Appliance CAM/CAS

If your CAM or CAS does not read the software on the CD-ROM drive, and instead attempts to boot
from the hard disk, use the following steps to configure the appliance to boot from CD-ROM before
attempting to re-image or upgrade the appliance from CD.
Step 1 Press the F10 key while the system is booting.
Step 2 Go to the Boot menu
Cisco NAC Appliance Hardware Installation Guide
3-40
Bits per second – 9600
Data bits – 8
Parity – None
Stop bits – 1
Flow control – None
.
Install the Clean Access Manager (CAM) Software from CD-ROM, page 3-5
Install the Clean Access Server (CAS) Software from CD-ROM, page 3-22
Perform the Initial CAM Configuration, page 3-6
Perform the Initial CAS Configuration, page 3-24
and run the
root service perfigo config
(Figure 3-11).
Chapter 3 Installing the Clean Access Manager and Clean Access Server
command.
OL-20326-01