Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual page 100

Installing the Clean Access Server
Figure 3-10
Specify the host name for the Clean Access Server (
Step 17
address when prompted:
Please enter the hostname [nacserver]: cas1
You entered cas1 Is this correct? (y/n)? [y]
Step 18 Specify the IP address of the Domain Name System (DNS) server in your environment. Type and
confirm the address when prompted:
Please enter the IP address for the name server: []: 172.10.16.16
You entered 172.10.16.16 Is this correct? (y/n)? [y]
The Clean Access Managers and Clean Access Servers use a local master secret password to encrypt and
Step 19
protect important data, like other system passwords. Cisco recommends keeping very accurate records
of assigned master secret passwords to ensure that you are able to restore database snapshots on the
CAM when you need them and are able to fail over to the HA peer CAM/CAS in HA deployments. (You
cannot upload a CAM database snapshot that was created when the system was configured with a
different master secret password, and HA-Secondary CAMs/CASs are not able to assume the "active"
role following a failover event when the master secret passwords are different.) Type and confirm the
master secret at the prompts.
The master secret is used to encrypt sensitive data.
Remember to configure all HA pairs with the same secret.
Please enter the master secret:
Please confirm the master secret:
If your master secret is lost or becomes corrupted, use the procedure in
Caution
Secret, page
Specify time settings for the Clean Access Server as follows:
Step 20
Choose your region from the continents and oceans list. Type the number next to your location on
a.
the list, such as
format, such as GST-10.
The next list that appears shows the countries for the region you chose. Choose your country from
b.
the country list, such as
If the country contains more than one time zone, the time zones for the country appears.
c.
Choose the appropriate time zone region from the list, such as
d.
Cisco NAC Appliance Hardware Installation Guide
3-30
Eth1 Egress Packets with Management VLAN ID Tagging
Untrusted network
Mgmt
ID
3-48.
for the Americas, and press Enter. Type
2
for the United States, and press Enter.
47
Chapter 3 Installing the Clean Access Manager and Clean Access Server
Trusted network
Clean Access
Server
Mgmt
ID
is the default). Type and confirm the
nacserver
11
packet
Recover From Corrupted Master
to enter the time zone in Posix TZ
for Pacific Time, and press Enter.
21
OL-20326-01