Useful Cli Commands For The Cam/Cas; Cam Cli Commands - Cisco NAC3350-PROF-K9 - NAC Profiler Server Installation Manual

Useful CLI Commands for the CAM/CAS

Useful CLI Commands for the CAM/CAS
This section covers CLI commands for both the Clean Access Manager and Clean Access Server:
•
•

CAM CLI Commands

You can perform most administration tasks for the Clean Access Manager through the web admin
console, such as configure behavior, and perform operations such as starting and rebooting the CAM.
However, in some cases you may need to access the CAM configuration directly, for example if the web
admin console is unavailable due to incorrect network or VLAN settings. You can use the Cisco NAC
Appliance command line interface (CLI) to set basic operational parameters directly on the CAM.
To run the CLI commands, access the CAM using SSH and log in as user
corresponding password. If already serially connected to the CAM, you can run CLI commands from the
terminal emulation console after logging in as
The format
lists the commonly used Cisco NAC Appliance CLI commands.
Table 3-3
Command
service perfigo start
service perfigo stop
service perfigo restart
service perfigo reboot
service perfigo config
service perfigo time
Power Down the CAM
To power down the CAM, use one of the following recommended methods while connected via SSH:
•
•
Cisco NAC Appliance Hardware Installation Guide
3-42
CAM CLI Commands, page 3-42
CAS CLI Commands, page 3-43
service perfigo <command>
CLI Commands
Description
Starts up the appliance. If the CAM is already running, a warning
message appears. The CAM must be stopped for this command to be
used.
Shuts down the Cisco NAC Appliance service.
Shuts down the Cisco NAC Appliance service and starts it up again. This
is used when the service is already running and you want to restart it.
Note
Shuts down and reboots the machine. You can also use the Linux
command.
Starts the configuration script to modify the CAM configuration. After
completing
Use to modify the time zone settings.
Type
service perfigo stop
Type , then power down the machine.
/sbin/halt
Chapter 3 Installing the Clean Access Manager and Clean Access Server
(see Connect the Clean Access Manager, page
root
is used to enter a command from the command line.
service perfigo restart
availability (failover). Instead, Cisco recommends "shutdown" or
"reboot" on the machine to test failover, or if a CLI command is
preferred,
service perfigo stop
service perfigo config
, then power down the machine, or
and enter the
root
should not be used to test high
and
service perfigo start
, you must reboot the CAM.
3-4).
Table 3-3
.
reboot
OL-20326-01