Perform the Initial System Configuration
The above SCE 1000 port parameters are fixed and are not configurable.
Step 1
Plug the <SKIP>serial cable provided with the SCE 1000 into the CON port on the front panel of the
SCE 1000.
Connect the other end of the serial cable (with an attached DB-9 connector) to the VT100 compatible
Step 1
local (serial) terminal.
At the console. press
Step 2
several times until the Cisco logo appears on the local terminal and the setup configuration dialog is
entered.
--- System Configuration Dialog ---
At any point you may enter a question mark '?' followed by 'Enter' for help.
Use ctrl-C to abort configuration dialog at any prompt.
Use ctrl-Z to jump to the end of the configuration dialog at any prompt.
Default settings are in square brackets '[]'.
Would you like to continue with the System Configuration Dialog? [yes/no]: y
Step 5
Type y and press press Enter.
Enters the system configuration dialog.
Perform the Initial System Configuration
•
•
•
•
•
•
•
•
•
•
•
Initial System Configuration
•
•
•
Cisco Service Control Engine 1000 2xGBE Quick Start Guide
4-2
Chapter 4
Initial System Configuration, page 4-2
Step 1: Configuring Initial Settings, page 4-6
Step 2: Configuring the Hostname, page 4-7
Step 3: Setting the Passwords, page 4-7
The Setup Command, page 4-3
Setup Command Parameters, page 4-4
Connect the Management Interfaces and Perform Initial System Configuration
OL-7822-06