Minolta MAGICOLOR 2350 User Manual page 161

9
Attach the front brackets.
a Pull open the front door of the
printer, and then pull out the lower
tray.
b Hook the tabs on the two brackets
into the mounting holes in the
printer, and then align the screw
holes in the brackets with the
screw holes in the lower feeder
unit.
c Using a screwdriver, tighten the
screws enclosed with the lower feeder unit to secure the brackets.
10
Close the right-side doors.
Attention
If the lower feeder unit is installed, the right-side door of the printer
opens at the same time that the right door of the lower feeder unit is
opened. Be sure to close the right door of the lower feeder unit when
closing the right-side door of the printer.
11
Slide the tray back into the printer.
12
Reattach the media support.
13
Reconnect the interface cable.
14
Reconnect the power cord, and turn
on the printer.
In compliance with UL
guidelines, "The appliance
inlet is considered to be the
main disconnect device."
Optional Lower Feeder Unit and Tray 2
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
159