Minolta MAGICOLOR 2350 User Manual page 163

2
Remove the rear panel from the
printer to access the controller board.
Using a screwdriver, loosen nine
screws on the top, left and bottom of
the panel, but do not remove them
from the printer.
3
Remove the two screws shown in the
illustration. Slide the panel slightly to
the right and lift it off the printer.
4
Next prepare the daughterboard for
installation. If you purchased an inter-
nal hard disk kit, skip to Step 6. If you
purchased a hard disk from another
vendor and purchased only the
daughterboard kit, you must now
attach the hard disk to the daughter-
board.
5
Attach the ribbon cable to the hard
disk, aligning Pin 1 on the cable to pin
1 on the hard disk.
6
With the cable connected, set the
hard disk flat on the daughterboard.
Then, using a screwdriver, insert the
four screws that came with the kit. Be
careful not to overtighten the screws.
7
Align the daughterboard over its con-
nector, matching Pin 1 on the daugh-
terboard to Pin 1 on the controller
board and matching the two white
nylon standoffs to the holes in the
controller board. Ease the pinned
connectors together and snap the
standoffs into place.
8
Slip the rear panel over the screws,
then slide it slightly left and tighten
the screws to secure the panel. Also
replace the two screws removed in
Step 3.
Installing an Internal Hard Disk
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
161