Minolta MAGICOLOR 2350 User Manual page 195

FCC Compliance Statement For American Users
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. Operation of this equipment in a residential area is
likely to cause harmful interference, in which case, the user will be required to correct the interference at his
own expense.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device must be used with shielded interface cables. The use of non-shielded cable is likely to result in
interference with radio communications, and is prohibited under FCC rules.
Attention
Any modifications or changes to this product not expressly approved in writing
by the manufacturer responsible for compliance to Federal Regulations could
void the user's authority to operate this product within the Laws and
Regulations of the Federal Communications Commission.
Regulatory Compliance Safety Information
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
193