Minolta MAGICOLOR 2350 User Manual page 134

Symptom Cause
The printer The printer pauses for
pauses. the color calibration
procedure (also
known as the
Auto-Image Density
Control [AIDC] cycle).
The length of this
automatic cycle
depends on
environmental factors,
number of pages
printed, and whether
a new toner or OPC
drum has been
installed.
This process ensures
reliable printer
operation with
optimum output
quality. If you open
the door before the
display reads
MAGICOLOR
2350/IDLE
printer stops and
repeats the calibration
cycle.
You cannot Your printer is not
access connected to a
PageScope network.
Light.
You cannot The administrator has
change the set a password in
options in PageScope Light or at
PageScope the printer's control
Light. panel.
132
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
Solution
Wait approximately 150 seconds
after rebooting your printer when
there has been an environmental
change such as in temperature or
humidity.
Wait approximately 170 seconds
after 200 1-sided pages of a
continuous print run.
Wait approximately 215 seconds
when the printer is "waking up" from
ENERGY SAVER and 1,000 or more
pages have been printed since the
last AIDC cycle.
Wait approximately 305 seconds
after the installation of a new toner
cartridge or OPC drum or if you start
an AIDC cycle manually using the
control panel or PageScope Light.
, the
Make sure your printer is connected to
your workstation via TCP/IP and that
you are using a supported Internet
browser.
Either obtain the password from your
system administrator or use printer
driver and application print dialog boxes
to set your preferences.
Solving Other Problems