Minolta MAGICOLOR 2350 User Manual page 95

7
Remove the protective yellow cover
clearly marked Remove.
Each toner cartridge has a
colored end that corresponds
to a colored label inside the
cartridge slots. Always install
the toner cartridge in the slot
with a label of the same color.
8
Support the middle of the cartridge
with your left hand, insert the thumb
and index finger of your right hand
into the two holes in the front of the
toner cartridge, and then insert the
cartridge so that the guides on the
cartridge fit into the rails in the
cartridge compartment in the
carousel.
9
Gently push the new toner cartridge
into the printer.
10
Close the printer's front door.
The printer must complete a 305-second calibration cycle after any
consumable has been replaced. If you open the door before the dis-
play reads MAGICOLOR 2350/IDLE
the calibration cycle.
Replacing a Toner Cartridge That Is Not Empty
You can choose to replace a toner cartridge that is not empty. For example, if
the consumable monitor on your printer driver indicates that a particular color
cartridge is running low and you need to print a lengthy job when no one will
be available to change the cartridge, you might want to replace the cartridge
before it is empty.
Here are the steps to replace the yellow toner.
Press Key
Replacing Consumables
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
, the printer stops and repeats
(Until) Display Reads
MAGICOLOR 2350
IDLE
93