Minolta MAGICOLOR 2350 User Manual page 18

EtherTalk Connection
a
You can connect via Ethernet in either of two ways:
Plug one end of a crossover Ethernet cable into the Macintosh and
the other into the printer's Ethernet port.
Use Ethernet patch cables and an Ethernet hub. Plug one end of
each patch cable into the hub, then plug the other end of one into
the Macintosh and the other end of the second into the printer's
Ethernet port.
b
Open the Chooser and select LaserWriter.
c
When your printer boots up, it finds a default zone. If your network has
more than one zone and you want to use a different zone, use the
Interface/Ethernet/Ethertalk/Name and Zone menus on the printer
control panel to specify the new zone.
The Name and Zone menus allow you to identify 1 zone with a
name up to 32 characters long. (Up to 16 characters can be
entered in each of the two menus). You cannot use these two
menus to identify two zones. Trailing spaces are not considered
part of the zone name. All standard printable ASCII characters are
valid except the @ and ' symbols. The names are case sensitive.
d
Choose Create and then Set-Up.
LPR Connection
a
You can connect via Ethernet in either of two ways:
Plug one end of a crossover Ethernet cable into the Macintosh and
the other into the printer's Ethernet port.
Use Ethernet patch cables and an Ethernet hub. Plug one end of
each patch cable into the hub, then plug the other end of one into
the Macintosh and the other end of the second into the printer's
Ethernet port.
b
Locate the Desktop Printer Utility.
If you cannot locate it on your Macintosh hard disk, it can be found on
your Macintosh's system CD-ROM.
c
Select Printer (LPR), and select
d
Type in the IP Address and use the same address for the Queue
name. Click OK.
e
Choose Create.
f
Name the printer with the IP Address or a descriptive name.
16 Installing Printer Drivers and Utilities, Macintosh
EDNord - Istedgade 37A - 9000 Aalborg - Telefon 9633 3500
OK
.