External Television Connection; External Audio Options - NEC VERSA 6200MX User Manual

External Television Connection

You can use a television as an external display device. Do so as follows:
In the Windows control panel, change the system display setting to
1.
640 x 480. (Display settings are found under Display Properties on the
Settings tab.)
Attach one end of an RCA-to-RCA cable to the NEC Versa TV Out port
2.
and to the Line In port on the TV.
Use
3. Fn+F3
NOTE
U.S. and Japan use the default NTSC signal; Hong Kong and most
European countries use the PAL signal. If you require the PAL set-
ting, you must go into Setup to change the setting.
The NEC Versa does not support the SECAM signals used in some
countries.

External Audio Options

The NEC Versa 6200MX comes equipped with built-in audio ports that let
you record and play sound.
Connect audio jacks, like a microphone, headphones, or external speakers to
the audio ports as follows.
1. Locate the audio port that you want to use.
Plug the jack into the port on the side of the NEC Versa 6200MX.
2.
to toggle to TV Out display mode.
The default TV Out setting is for NTSC transmission. The
Using Your NEC Versa 6200MX 4-43