Installing A Device In The Versabay Ii - NEC VERSA 6200MX User Manual

Continue to hold the latch near the front of the system and pull the device
6.
the rest of the way out of the system.
NOTE
device, the device casing catches on the inside of the latch.

Installing a Device in the VersaBay II

Use the following steps to install a device in the VersaBay II. These steps
show how to install the 10X CD-ROM reader that ships standard with the
system. Use these steps for installing other devices as well.
NOTE
fied as a slave device in the Setup utility. Also, check that the switch
on the back of the reader is set to the right (positioned next to the S
for Slave).
If you install a hard disk drive from a Versa model E, V, M, or P in
the VersaBay II, it becomes the master drive from which the system
boots.
4-8 Using Your NEC Versa 6200MX
If you release the front latch before completely removing the
A CD-ROM reader installed in the VersaBay II must be speci-
Releasing the device