NEC VERSA 6200MX User Manual page 130

MESSAGE
Diskette drive A or B
failure or No Floppy
Drive or FDC Failure
Invalid system disk
Diskette boot failure
Non-system disk or
disk error; Replace
and strike any key
when ready
Operating System Not
Found
or
C: drive failure
No ROM BASIC
CMOS settings wrong –
run Setup.
Press F1 to resume
Real time clock
failure
CMOS Battery state
low
CMOS date and time
not set
CMOS memory size
mismatch
7-4 Solving Problems
POST Error Messages
WHAT TO DO
Drive A does not work or is not properly connected.
Drive A is the diskette drive.
Check that drive A is securely connected and power
is on.
Press to start Setup to check the diskette drive
F2
parameters.
If there's still a problem, the drive might need repair.
Replace the disk and then press any key.
Insert a bootable disk in drive A and press any other
key.
Remove the diskette from drive A and press any key
to start the system from the hard disk.
Or, insert a bootable disk in drive A and press any
key.
Press to start Setup. Change the hard disk type to
F2
the correct setting. Exit and save Setup changes.
No bootable sector is found on either drive A or drive
C. Remove the installed diskette and use a bootable
diskette.
One or more system configuration parameters are
not properly set. Press F1 to start Setup, correct the
settings, exit and save to update the parameters.
Set time and date using Setup. Exit and save to
update the parameters.
Have an authorized NEC dealer replace the CMOS
battery.
Set the time and date using Setup. Exit and save
Setup changes to update the parameters.
Run Setup to reset the amount of memory defined
on the motherboard.