NEC VERSA 6200MX User Manual page 131

POST Error Messages
MESSAGE
System CMOS
Checksum failure – run
Setup Press (F1) to
resume.
Fixed disk configuration
error
C: drive error or failure
Hard Disk controller
failure
Keyboard controller
failure
Keyboard Error
KB\interface error
WHAT TO DO
Press F2 to enter Setup. Under Exit, set the default
values. Under Main, set the date and time. Save
your changes and exit.
Start Setup. Exit and save to update the parameters.
Check to see if the hard disk connector is seated
properly. If there is still a problem, the hard disk
might need repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.
If there is still a problem, the hard disk might need
repair.
Press F2 to start Setup. Exit and save to update the
parameters.
Check to see if the hard disk connector is seated
properly.
The hard disk controller does not work and might
need repair.
Unplug external keyboard if attached and reboot the
system. If it still fails, have the system repaired.
NOTE
Repeated keystrokes during boot may
produce an error message .
A timing problem exists with the keyboard. If the
error message remains, the keyboard may have to
be repaired.
Error exists in keyboard connector. If the error
message remains, the keyboard may have to be
repaired.
Solving Problems 7-5