Renault MASTER 2024 User Manual page 191

GEAR CONTROL
then release the lever: it will return to
the stable position.
The position engaged lights up on the
instrument panel.
If certain conditions prevent shifting
from one position to another, the cur­
rent position flashes on the instrument
panel.
To disengage position P
With the vehicle stationary and the en­
gine running, press the brake pedal
and move the selector lever A or B
upwards or downwards to engage the
desired position.
If the brake pedal is not fully pressed,
the "Press brake pedal" message and
the warning light are displayed
on the instrument panel.
To engage position P
With the vehicle stationary, the engine
on or the ignition on and the brake
pedal pressed, press button 2 to en­
gage P position.
In some cases (e.g. parking
on a slope), with the brake
pedal pressed, apply the
parking brake �� 196 before en­
gaging P position.
Check that the P warn­
ing light on the instru­
ment panel is displayed
before leaving the vehi­
cle.
Risk of loss of immobilisation
of the vehicle
To engage neutral
With the vehicle stationary and the en­
gine running, to engage N position it is
necessary to press the brake pedal be­
fore shifting the selector lever A or B
one notch upwards or downwards.
Driving in automatic mode
With the vehicle stationary, the engine
on and the brake pedal pressed, shift
the selector lever A or B two notches
downwards to engage D position.
If one of the conditions is not met, the
current position flashes for approxi­
mately five seconds and the "Press
brake pedal" message is displayed on
the instrument panel for approximately
five seconds.
In most traffic conditions, you will not
have to touch the gear lever.
Note: with the engine on and the vehi­
cle moving between approximately 0
and 5 mph (8 km/h), in N or R position,
the brake pedal must be pressed to
engage D position.
Forward gear with regenerative
braking
(depending on the vehicle)
With the selector lever B in D position,
push the lever downwards to activate
regenerative braking. To deactivate the
function, push the lever downwards or
change the gear.
To select reverse gear
With the vehicle stationary and the en­
gine on, shift the selector lever A or B
two notches upwards to engage R po­
sition.
If the brake pedal is not pressed, a
beep will sound, the display of the cur­
rent position flashes for approximately
five seconds in the grid shown on the
instrument panel and the "Press brake
pedal" message is displayed for ap­
proximately five seconds.
D r i v i n g - 1 8 9
3