Lazer Safe PCSS-A Series Technical Manual page 9

LS-CS-M-046 PCSS-A Series Technical Manual
Copyright Information
"Lazer Safe", "Press Control Safety System", "PCSS", "PCSS-A", "LZS-LG", "LZS-LG-HS", "LZS-004", "LZS-004-HS"," LZS-
1", "LZS-2", "LZS-2-FG", "LZS-R", "LZS-XL", "LZS-005", "IRIS", "IRIS Plus", "RapidBend", "RapidBend Plus", "RapidBend
Ultimate", "FlexSpeed", "FlexSpeed Plus", "SmartLink", "BendShield", "BendShield Plus", "AutoSense", "AutoSense Plus",
"AutoSense Ultimate", "BullRoarer", "Sentinel", "Sentinel Plus", "Defender", "Defender Plus", "FoldGuard", "PressGuard" and
"LazerGuard" are trademarks of Lazer Safe Pty Ltd.
ISaGRAF is a registered trademark of Rockwell Automation, Inc.
Microsoft and Windows are either registered trademarks or trademarks of Microsoft Corporation in the U.S.A. and / or other
countries.
The content of this manual is supplied for informational use only, is subject to change without notice and should not be
construed as a commitment by Lazer Safe Pty Ltd. Lazer Safe Pty Ltd assumes no responsibility or liability for any errors,
inaccuracies or omissions that may appear within this publication.
Copyright in this documentation is owned by Lazer Safe Pty Ltd. No part of this document may be reproduced or copied in
any form or by any means (graphic, electronic, or mechanical including photocopying, recording, taping, or information storage
and retrieval systems) without the written permission of Lazer Safe Pty Ltd.
Lazer Safe's copyright in this document is protected by Australian copyright laws (including the Copyright Act 1948
(Commonwealth)) and by international copyright treaties.
© 2024 Lazer Safe Pty Ltd. All rights reserved.
Page vii
Original Language Version: 1.25 Released: 12/09/2024