Sartorius Entris II Advanced Series Operating Instructions Manual page 24

Operating Concept
4.11.6 Parameters in the "Settings / Printout" Menu
Parameters Settings
Printout Manual
without
stability
Manual with
stability*
Auto without
stability
Auto without
stability
Print after
weight
change
* Factory setting
4.11.7 Parameters in the "Settings / Printout / Manual Print" Menu
Parameters Settings
ISO / GLP On
printout
Off*
Tare after On
print
Off*
Manual print Value*
format
Date, Value
Value (N, T,
G#)
Date, Value
(N, T, G#)
* Factory setting
24 Entris II Advanced Line Operating Instructions
®
Explanation
The print process can be started manually at any time.
If the [Print] button is pressed: The print command is only executed once
stability is achieved.
− The data is printed automatically.
− No stability is required for printout.
− The printout can be without unit symbols.
− The data is printed automatically.
− No stability is required for printout.
Prints after a threshold for device stability has been exceeded and the weight
has previously been reduced to less than half of the threshold.
Explanation
Activates the ISO / GLP printout.
Deactivates the ISO / GLP printout.
Tares the device automatically after every printout.
Deactivates automatic taring after printout.
Prints the weight value.
Prints the weight value and a time stamp.
Prints a weight value block (net, tare, calculated gross).
Prints a time stamp and a weight value block (net, tare, calculated gross value).