Zone Edit - ZyXEL Communications ZYWALL USG 20 Manual

Chapter 15 Zones

15.3 Zone Edit

The Zone Edit screen allows you to add or edit a zone. To access this screen, go
to the Zone screen (see
Edit icon.
Figure 199 Network > Zone > Add
The following table describes the labels in this screen.
Table 90 Network > Zone > Edit
LABEL
Name
Block Intra-
zone Traffic
Member List
OK
Cancel
330
Section 15.2 on page
DESCRIPTION
For a system default zone, the name is read only.
For a user-configured zone, type the name used to refer to the zone. You
may use 1-31 alphanumeric characters, underscores(
but the first character cannot be a number. This value is case-sensitive.
Select this check box to block network traffic between members in the
zone.
Available lists the interfaces and VPN tunnels that do not belong to any
zone. Select the interfaces and VPN tunnels that you want to add to the
zone you are editing, and click the right arrow button to add them.
Member lists the interfaces and VPN tunnels that belong to the zone.
Select any interfaces that you want to remove from the zone, and click
the left arrow button to remove them.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
329), and click the Add icon or an
), or dashes (-),
_
ZyWALL USG 20/20W User's Guide