Licensing Registration; Interface; Trunks; Policy Routes - ZyXEL Communications ZYWALL USG 20 Manual

Chapter 6 Configuration Basics

6.5.2 Licensing Registration

Use these screens to register your ZyWALL and subscribe to services like more
SSL VPN tunnels, and content filtering. You must have Internet access to
myZyXEL.com.
MENU ITEM(S)
PREREQUISITES

6.5.3 Interface

See Section 6.2 on page 88
Note: When you create an interface, there is no security applied on it until you assign
it to a zone.
Most of the features that use interfaces support Ethernet, PPPoE/PPTP, cellular,
VLAN, and bridge interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: The dmz interface is in the DMZ zone and uses a private IP address. To
configure dmz's settings, click Network > Interface > Ethernet and then the
dmz's Edit icon.

6.5.4 Trunks

Use trunks to set up load balancing using two or more interfaces.
MENU ITEM(S)
PREREQUISITES
WHERE USED
Example: See

6.5.5 Policy Routes

Use policy routes to override the ZyWALL's default routing behavior in order to
send packets through the appropriate interface or VPN tunnel. You can also use
policy routes for bandwidth management (out of the ZyWALL), port triggering,
96
Configuration > Licensing > Registration
Internet access to myZyXEL.com
for background information.
Configuration > Network > Interface (except Network >
Interface > Trunk)
Port groups (configured in the Interface > Port Grouping screen)
Zones, trunks, IPSec VPN, DDNS, policy routes, static routes, HTTP
redirect, NAT
Configuration > Network > Interface > Trunk
Interfaces
Policy routes
Chapter 7 on page 107.
ZyWALL USG 20/20W User's Guide