Service Control Rules; Customizing The Www Login Page - ZyXEL Communications ZYWALL USG 20 Manual

Chapter 43 System
Table 200 Configuration > System > WWW > Service Control (continued)
LABEL
Apply
Reset

43.7.5 Service Control Rules

Click Add or Edit in the Service Control table in a WWW, SSH, Telnet, FTP or
SNMP screen to add a service control rule.
Figure 379 Configuration > System > Service Control Rule > Edit
The following table describes the labels in this screen.
Table 201
LABEL
Create new
Object
Address
Object
Zone
Action
OK
Cancel

43.7.6 Customizing the WWW Login Page

Click Configuration > System > WWW > Login Page to open the Login Page
screen. Use this screen to customize the Web Configurator login screen. You can
650
DESCRIPTION
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Configuration > System > Service Control Rule > Edit
DESCRIPTION
Use this to configure any new settings objects that you need to use in
this screen.
Select ALL to allow or deny any computer to communicate with the
ZyWALL using this service.
Select a predefined address object to just allow or deny the computer
with the IP address that you specified to access the ZyWALL using this
service.
Select ALL to allow or prevent any ZyWALL zones from being accessed
using this service.
Select a predefined ZyWALL zone on which a incoming service is allowed
or denied.
Select Accept to allow the user to access the ZyWALL from the specified
computers.
Select Deny to block the user's access to the ZyWALL from the specified
computers.
Click OK to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving
ZyWALL USG 20/20W User's Guide