The Http Redirect Screen - ZyXEL Communications ZYWALL USG 20 Manual

Finding Out More
See Section 6.5.10 on page 99

18.2 The HTTP Redirect Screen

To configure redirection of a HTTP request to a proxy server, click Configuration
> Network > HTTP Redirect. This screen displays the summary of the HTTP
redirect rules.
Note: You can configure up to one HTTP redirect rule for each (incoming) interface.
Figure 209 Configuration > Network > HTTP Redirect
The following table describes the labels in this screen.
Table 96 Configuration > Network > HTTP Redirect
LABEL
Add
Edit
Remove
Activate
Inactivate
#
Status
Name
Interface
Proxy Server
Port
Apply
Reset
ZyWALL USG 20/20W User's Guide
for related information on these screens.
DESCRIPTION
Click this to create a new entry.
Double-click an entry or select it and click Edit to open a screen where
you can modify the entry's settings.
To remove an entry, select it and click Remove. The ZyWALL confirms
you want to remove it before doing so.
To turn on an entry, select it and click Activate.
To turn off an entry, select it and click Inactivate.
This field is a sequential value, and it is not associated with a specific
entry.
This icon is lit when the entry is active and dimmed when the entry is
inactive.
This is the descriptive name of a rule.
This is the interface on which the request must be received.
This is the IP address of the proxy server.
This is the service port number used by the proxy server.
Click Apply to save your changes back to the ZyWALL.
Click Reset to return the screen to its last-saved settings.
Chapter 18 HTTP Redirect
349