ZyXEL Communications ZYWALL USG 20 Manual page 168

Chapter 8 Dashboard
Table 19 Dashboard (continued)
LABEL
Device
Status
Zone
IP Address/
Mask
Device
Device
Information
System
Name
Model
Name
Serial
Number
MAC
Address
Range
Firmware
Version
System Status
System
Uptime
Current
Date/Time
VPN Status
168
DESCRIPTION
This field displays the name of the device connected to the extension slot
(or none if no device is detected).
This field displays the current status of each interface or device installed
in a slot. The possible values depend on what type of interface it is.
For Ethernet interfaces:
Inactive - The Ethernet interface is disabled.
Down - The Ethernet interface does not have any physical ports
associated with it or the Ethernet interface is enabled but not connected.
Speed / Duplex - The Ethernet interface is enabled and connected.
This field displays the port speed and duplex setting (Full or Half).
(For USG 20W only) The status for an installed WLAN card is none.
For cellular (3G) interfaces, see
that can appear.
This field displays the zone to which the interface is currently assigned.
This field displays the current IP address and subnet mask assigned to
the interface. If the interface is a member of an active virtual router, this
field displays the IP address it is currently using. This is either the static
IP address of the interface (if it is the master) or the management IP
address (if it is a backup).
This identifies a device installed in one of the ZyWALL's extension slots
or USB ports.
This field displays the name used to identify the ZyWALL on any
network. Click the icon to open the screen where you can change it. See
Section 43.2 on page 630.
This field displays the model name of this ZyWALL.
This field displays the serial number of this ZyWALL.
This field displays the MAC addresses used by the ZyWALL. Each physical
port has one MAC address. The first MAC address is assigned to physical
port 1, the second MAC address is assigned to physical port 2, and so
on.
This field displays the version number and date of the firmware the
ZyWALL is currently running. Click the icon to open the screen where
you can upload firmware. See
This field displays how long the ZyWALL has been running since it last
restarted or was turned on.
This field displays the current date and time in the ZyWALL. The format
is yyyy-mm-dd hh:mm:ss.
Click this to look at the VPN tunnels that are currently established. See
Section 8.2.1 on page 171.
Section 11.5 on page 239
Section 45.3 on page 700.
ZyWALL USG 20/20W User's Guide
for the status