ZyXEL Communications ZYWALL USG 20 Manual page 193

Table 35 Monitor > System Status > Cellular Status (continued)
LABEL
Status
Service Provider
ZyWALL USG 20/20W User's Guide
DESCRIPTION
No device - no 3G device is connected to the ZyWALL.
No Service - no 3G network is available in the area; you cannot
connect to the Internet.
Limited Service - returned by the service provider in cases where the
SIM card is expired, the user failed to pay for the service and so on;
you cannot connect to the Internet.
Device detected - displays when you connect a 3G device.
Device error - a 3G device is connected but there is an error.
Probe device fail - the ZyWALL's test of the 3G device failed.
Probe device ok - the ZyWALL's test of the 3G device succeeded.
Init device fail - the ZyWALL was not able to initialize the 3G device.
Init device ok - the ZyWALL initialized the 3G card.
Check lock fail - the ZyWALL's check of whether or not the 3G device
is locked failed.
Device locked - the 3G device is locked.
SIM error - there is a SIM card error on the 3G device.
SIM locked-PUK - the PUK is locked on the 3G device's SIM card.
SIM locked-PIN - the PIN is locked on the 3G device's SIM card.
Unlock PUK fail - Your attempt to unlock a WCDMA 3G device's PUK
failed because you entered an incorrect PUK.
Unlock PIN fail - Your attempt to unlock a WCDMA 3G device's PIN
failed because you entered an incorrect PIN.
Unlock device fail - Your attempt to unlock a CDMA2000 3G device
failed because you entered an incorrect device code.
Device unlocked - You entered the correct device code and unlocked
a CDMA2000 3G device.
Get dev-info fail - The ZyWALL cannot get cellular device information.
Get dev-info ok - The ZyWALL succeeded in retrieving 3G device
information.
Searching network - The 3G device is searching for a network.
Get signal fail - The 3G device cannot get a signal from a network.
Network found - The 3G device found a network.
Apply config - The ZyWALL is applying your configuration to the 3G
device.
Inactive - The 3G interface is disabled.
Active - The 3G interface is enabled.
Incorrect device - The connected 3G device is not compatible with
the ZyWALL.
Correct device - The ZyWALL detected a compatible 3G device.
Set band fail - Applying your band selection was not successful.
Set band ok - The ZyWALL successfully applied your band selection.
Set profile fail - Applying your ISP settings was not successful.
Set profile ok - The ZyWALL successfully applied your ISP settings.
PPP fail - The ZyWALL failed to create a PPP connection for the cellular
interface.
Need auth-password - You need to enter the password for the 3G
card in the cellular edit screen.
Device ready - The ZyWALL successfully applied all of your
configuration and you can use the 3G connection.
This displays the name of your network service provider. This shows
Limited Service if the service provider has stopped service to the 3G
SIM card. For example if the bill has not been paid or the account has
expired.
Chapter 9 Monitor
193