ZyXEL Communications ZYWALL USG 20 Manual page 769

Table 251 Policy Route Logs (continued)
LOG MESSAGE
The policy route %d
uses empty source
address group!
The policy route %d
uses empty destination
address group!
The policy route %d
uses empty service
group
Policy-route rule %d
was inserted.
Policy-route rule %d
was appended.
Policy-route rule %d
was modified.
Policy-route rule %d
was moved to %d.
Policy-route rule %d
was deleted.
Policy-route rules
were flushed.
BWM has been
activated.
BWM has been
deactivated.
Interface %s alive,
related policy route
rules will be re-
enabled
Interface %s dead,
related policy route
rules will be disabled
Trunk %s alive,
related policy route
rules will be re-
enabled
Trunk %s dead, related
policy route rules
will be disabled
ZyWALL USG 20/20W User's Guide
DESCRIPTION
Use an empty object group.
%d: the policy route rule number
Use an empty object group.
%d: the policy route rule number
Use an empty object group.
%d: the policy route rule number
Rules is inserted into system.
%d: the policy route rule number
Rules is appended into system.
%d: the policy route rule number
Rule is modified.
%d: the policy route rule number
Rule is moved.
1st %d: the original policy route rule number
2nd %d: the new policy route rule number
Rule is deleted.
%d: the policy route rule number
Policy routing rules are cleared.
The global setting for bandwidth management on the ZyWALL
has been turned on.
The global setting for bandwidth management on the ZyWALL
has been turned off.
An interface came back up so the ZyWALL will use the related
policy route rules again.
An interface went down so the ZyWALL will stop using the
related policy route rules.
A trunk came back up so the ZyWALL will use the related
policy route rules again.
A trunk went down so the ZyWALL will stop using the related
policy route rules.
Appendix A Log Descriptions
769