ZyXEL Communications ZYWALL USG 20 Manual page 73

Table 11 WAN and ISP Connection Settings (continued)
LABEL
Authentication
Type
User Name
Password
Retype to
Confirm
Nailed-Up
Idle Timeout
PPTP
Configuration
Base Interface This displays the identity of the Ethernet interface you configure to
Base IP
Address
IP Subnet
Mask
Server IP
Connection ID
WAN Interface
Setup
WAN Interface This displays the identity of the interface you configure to connect
Zone
IP Address
ZyWALL USG 20/20W User's Guide
DESCRIPTION
Use the drop-down list box to select an authentication protocol for
outgoing calls. Options are:
CHAP/PAP - Your ZyWALL accepts either CHAP or PAP when
requested by this remote node.
CHAP - Your ZyWALL accepts CHAP only.
PAP - Your ZyWALL accepts PAP only.
MSCHAP - Your ZyWALL accepts MSCHAP only.
MSCHAP-V2 - Your ZyWALL accepts MSCHAP-V2 only.
Type the user name given to you by your ISP. You can use
alphanumeric and -_
@$./
characters long.
Type the password associated with the user name above. Use up to 64
ASCII characters except the [] and ?. This field can be blank.
Type your password again for confirmation.
Select Nailed-Up if you do not want the connection to time out.
Type the time in seconds that elapses before the router automatically
disconnects from the PPPoE server. 0 means no timeout.
This section only appears if the interface uses a PPPoE or PPTP
Internet connection.
connect with a modem or router.
Type the (static) IP address assigned to you by your ISP.
Type the subnet mask assigned to you by your ISP (if given).
Type the IP address of the PPTP server.
Enter the connection ID or connection name in this field. It must
follow the "c:id" and "n:name" format. For example, C:12 or N:My
ISP.
This field is optional and depends on the requirements of your DSL
modem.
You can use alphanumeric and -_
characters long.
with your ISP.
This field displays to which security zone this interface and Internet
connection will belong.
This field is read-only when the WAN interface uses a dynamic IP
address. If your WAN interface uses a static IP address, enter it in this
field.
Chapter 5 Quick Setup
characters, and it can be up to 31
characters, and it can be up to 31
:
73